Shower Handpiece
Instructions:

   

TP0114_instruction_01.jpg

TP0114_instruction_02.jpg

TP0114_instruction_03.jpg

Remove any existing 
flow restrictor
Install the Oxijet™ and 
ensure the seal is attached
between fittings
Ready to use. 

1) Unscrew handpiece from the hose.

2) Ensure there is no lime and calcium build up in the handpiece. Any restrictor after the Oxijet™ will reduce its effectiveness. Restrictors may include lime scale, or simply restriction in the handpiece or shower head itself.* To remove lime and calcium build up: Soak handpiece in a water and white vinegar solution.

3) Remove any flow restrictors between hose and handpiece, or hose and wall elbow.

4) Ensure there is no flow restrictor built into the handpiece.NB: If this can't be removed, your Oxijet™ may not aerate to its full potential.

5) Screw the yellow Oxijet™ into the handpiece. The water flow should flow in the same direction as the arrow on the Oxijet™. Ensure any washer supplied is in place before securing the Oxijet™.

6) With the hose washer left inside the hose, screw the Oxijet™ and handpiece into the hose.

     
   Note: The Oxijet™ is optimised for Felton shower handpieces and DIN EN1113 rated hoses. Only use with non-restrictive (all pressures) handpieces. Do not use non DIN EN1113 rated standard hoses and may not be compatible with some handpieces.Operating pressures : Minimum 300 kPa | Maximum 1000 kPaOperating temperature : Maximum 80°C

 

joomla template 1.6